HP BL860C - Manual (Page 158)

boottest off Skip all tests (for a faster boot time)
boottest [test] Displays status of specific Speedy Boot bit
boottest [test] [on|off] Sets or clears a specific Speedy Boot bit
Parameters
[test] Each test can be set or cleared:
booting_valid Enable/disable system firmware response to BOOTING
bit. If OS Speedy Boot aware set to on.
early_cpu Enable/disable early CPU selftests.
late_cpu Enable/disable late CPU selftests.
platform Enable/disable system board hardware tests.
chipset Enable/disable CEC tests.
io_hw Enable/disable EFI driver Core I/O tests.
mem_init Enable/disable memory initialization.
mem_test Enable/disable full destructive memory tests.
Example 6 boottest Command
Shell> boottest
BOOTTEST Settings Default Variable
Selftest Setting
------------- -------------------------
booting_valid On (OS speedy boot aware)
early_cpu Run this test
late_cpu Run this test
platform Run this test
chipset Run this test
io_hw Run this test
mem_init Run this test
mem_test Run this test
Example 7 boottest early_cpu off Command
Shell> boottest early_cpu off
BOOTTEST Settings Default Variable
Selftest Setting
------------- -------------------------
booting_valid On (OS speedy boot aware)
early_cpu Skip this test
late_cpu Run this test
platform Run this test
chipset Run this test
io_hw Run this test
mem_init Run this test
mem_test Run this test
cpuconfig
Use this command to display the configured or deconfigured state of processors in the server. This
command also enables you to configure or reconfigure processors.
Syntax
cpuconfig
Parameters
specify a processor
state to set the processor to
Operation
Issuing cpuconfig with no parameters displays the config/deconfig status of all processors. A
user can reconfigure processors by specifying a processor number and a state (on or off). If a valid
158 Utilities