HP BL860C - Manual (Page 118)

Figure 45 Alignment Holes in Processor Slot 0
3. Slide the processor sequencer to the right and hold it to uncover the ZIF socket.
4. Tighten the ZIF socket with the with the 2.5-mm hex end of the processor installation tool by
turning the socket 180 degrees clockwise.
See Figure 46 .
Figure 46 ZIF Socket on Processor Slot 0
5. Release the processor sequencer.
6. Tighten the captive shoulder screws (1 - 4) on the processor heat sink with the Torx T-15
screwdriver.
See Figure 47 (page 119) .
7. Tighten the captive screws (5 - 6) on the processor with the Torx T-15 screwdriver.
118 Removing and Replacing Components