Installing a processor, Figure 43 – HP BL860C User Manual

Page 117

Figure 43 ZIF Socket on the Processor

Carefully remove the processor module by lifting it straight up from the system board.

Place the processor module in an antistatic bag.

Installing a Processor

To install the processor:
1.

Ensure the ZIF socket for the processor you are installing is open.

Insert the 2.5 mm hex end of the Torx T-15 screwdriver into the ZIF socket and gently try to
rotate the socket 180 degrees counter clockwise. If the socket doesn’t turn, the socket is open.

See

Figure 44 (page 117)

NOTE:

If you have just removed a processor, the ZIF socket is unlocked.

Figure 44 ZIF Socket Unlocked

Carefully insert the processor module into the empty processor slot (processor slot 0 is shown)
on the server blade system board; then line up the guide pins on the processor to the alignment
holes in the processor slot to seat the processor.

See

Figure 45

for the alignment hole locations for processor slot 0.

Removing and Replacing a Processor

117