HP BL860C - Manual (Page 119)

Figure 47 Installing a Processor in Slot 0
8. Connect the power cable to the power connector on the processor.
9. Install the access panel.
See “Replacing the Server Blade Access Panel” (page 112) .
10. Place the server blade back into the enclosure and power it up.
See “Replacing the Server Blade in the Enclosure” (page 111) .
Removing and Replacing the SAS Backplane
The following procedures describe how to remove and replace a failed SAS backplane. The server
blade backplane supports two SAS disk drives on the SAS backplane.
Removing the SAS Backplane
To remove the failed SAS backplane from the server blade:
1.
Power off the server and remove it from the enclosure.
See “Preparing the Server Blade for Servicing” (page 110) .
2. Remove the access panel. See “Removing the Server Blade Access Panel” (page 112) .
3. Remove the SAS disk drives or disk drive blanks.
See “Removing a SAS Disk Drive” (page 108) , or “Removing a Disk Drive Blank” (page 109) .
4. Remove the access panel.
See “Removing the Server Blade Access Panel” (page 112) .
Removing and Replacing the SAS Backplane 119