Epson EM07ZS1647F - Manual (Page 49)

2. Installation
2.7.6 Slave Mode
(1) Ensure that the board is connected to the fieldbus. Then, start the applicomIO
console application.
(2) Click on the “Protocol list” under the board that was just added.
(3) Select Protocol | Properties.
(4) Configure the baud rate, MAC ID (slave address), and so on for the DeviceNet
network. In this example, the MAC ID (slave address) is set to 005.
Specify an unused address on the network for a slave device as well as other devices.
(5) Double-click the “DeviceNet Local Slave” item.
) NOTE
Fieldbus I/O Rev.6 37