Epson EM07ZS1647F - Manual (Page 38)

2. Installation
2.7 DeviceNet Board Installation
Following two types can be used for the fieldbus I/O option DeviceNet.
- PCU-DVNIO
- PCI-DVNIO
2.7.1 Board Appearance
Part names and functions of the scanner board are shown in the following figure.
For details of the status display LEDs (Module/NetWork LED and IO LED), refer to the 4.
Troubleshooting in this manual.
PCU-DVNIO
LED (2)
(Not in use)
RJ45 Connector
(Not in use)
C0 C1 C2
JP1
JP1
0
1
4-pin Terminal
Watchdog Port
(Do not use this port.)
Status Display LED (2)
DeviceNet Port
Jumper for Board Address
PCI-DVNIO
C0 C1 C2
JP1
JP1
0
1
4-pin Terminal
Watchdog Port
(Do not use this port.)
Male 9-pin D-Sub
Port for Board Configuration
Status Display LED (2)
Left: Module/NetWork LED
Right: IO LED
DeviceNet Port
Jumper for Board Address
26 Fieldbus I/O Rev.6