Epson EM07ZS1647F User Manual

Page 29

2. Installation

(2) Carefully expand the meshes of the braided shield.

Under the braided shield, there is one exposed bare
twisted shield wire other than the signal wires and
power wires that are wrapped with aluminum tape. The
shield wire is slightly harder than the mesh.

Shield Wire

(3) Cut off the expanded braided shield and remove the

aluminum tape around the signal wires and power
wires. Then, strip the insulation from the signal wires
and power wires for a length sufficient to connect them
to crimp terminals.
Twist each stripped signal wire and power wire.

Peel the coverings in enough
length to connect the wires to

crimping terminals.

(4) Set the crimp terminal on the stripped part of the wire

and crimp it with a crimp tool. The following crimping
terminals are recommended products.

Crimping

Terminal

NICHIFU TC series

Model Number

Specifications Special

Tool

TMEV TC-0.5

For Thin Cable

TMEV TC-2-11

For Thick Cable (power wire)

TMEV TC-1.25-11

For Thick Cable (signal wire)

MH-32

Phoenix Contact AI series

Model Number

Specifications Special

Tool

AI 0.5-8WH

For Thin Cable (power cable)

AI 0.25-8YE

For Thin Cable (signal wire)

AI 2.5-8BU

For Thick Cable (signal wire)

AI 1-8RD

For Thick Cable (signal wire)

CRIMPFOX UD6

(5) Wrap or cover the cable with vinyl tape or heat-shrink

tubing.

Heat-shrinkable Tube, etc.

Loosen the screws securing the cables on the connector. If the screws are not loosened, the
wires go into different openings on the rear of connector instead of the correct openings
and the wires cannot be secured.

(6) Ensure the correct connector orientation and insert the

signal wires and shield wire to their respective holes
on the connector.
As shown in the figure, insert the wires (black, blue,
shield, white, and red) into the holes in the order
named.
The following table shows the specified colors of the
cables.

Color

Details of Signal

Wire Identity

a Black Communications

Power

Supply (negative)

V-

b Blue

Signal (Low)

CAN L

c -

Shield

d White Signal (High)

CAN H

e Red Communications

Power

Supply (positive)

V+

Insert the

connector

in this

direction.

Insert wires in

this direction.

)

NOTE

Fieldbus I/O Rev.6