KORG ARP 2600 M Analog Synthesizer Module with Carrying Case - Manual (Page 8)

ARP 2600 M
- 8 -
Front panel (VCO-2 section)
a
b
g
c
n
o
i
j
k
l
m
d e f h
p
q
VCO-2 (Voltage Controlled Oscilator 2)
a . INITIAL OSCILLATOR FREQUENCY
slider . . . . . . [10( .03)Hz…10K(30 .)Hz]
Broadly adjusts the VCO-2 pitch.
The frequency range is an
approximate value.
b . FINE TUNE slider
Finely adjusts the VCO-2 pitch.
c . PULSE WIDTH slider
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [10%…90%]
Adjusts the duty cycle of the VCO-2
pulse wave.
d . CV input 1 jack
This is the pitch CV input jack for
VCO-2. The KBD CV is internally
connected.
e . CV input 2 jack
This is the pitch CV input jack for
VCO-2. The S/H OUT is internally
connected.
f . CV input 3 jack
This is the pitch CV input jack for
VCO-2. The ADSR is internally
connected.
g . CV input 4 jack
This is the pitch CV input jack for
VCO-2. The square wave of VCO-1
is internally connected.
h . PULSE WIDTH MODULATION
input jack
This is the input jack for the CV that
controls the duty cycle of the
VCO-2 pulse wave output. The
noise generator is internally
connected.
i . AUDIO/LF select switch
. . . . . . . . . . . . . . . . . . . . . . . . [KBD ON, KBD OFF]
Selects whether to use VCO-2 as an
audio signal or as an LFO. When
using VCO-2 as an LFO (KBD OFF),
the KBD CV will no longer be input
into VCO-2.
j . CV input 2 level slider
Adjusts the signal level of VCO-2
CV input 2.
k . CV input 3 level slider
Adjusts the signal level of VCO-2
CV input 3.
l . CV input 4 level slider
Adjusts the signal level of VCO-2
CV input 4.
m . PULSE WIDTH MODULATION
input level slider
Adjusts the amount of pulse width
modulation.
n . TRIANGLE output jack
Outputs the triangle wave of VCO-2.
o . SAWTOOTH output jack
Outputs the sawtooth wave of
VCO-2.
p . PULSE output jack
Outputs the pulse wave of VCO-2.
q . SINE output jack
Outputs the sine wave of VCO-2.