KORG ARP 2600 M Analog Synthesizer Module with Carrying Case - Manual (Page 15)

- 15 -
Owner
’s manual
Front panel (SAMPLE & HOLD section)
a
b
c
d
e f
h
i
g
SAMPLE & HOLD
a . SAMPLE & HOLD input jack
This is the input jack for the sample & hold circuit. The noise generator is
internally connected.
b . INT CLOCK OUT jack
Outputs the clock signal of the clock generator built into this unit.
c . S/H OUT jack
Outputs the sample & hold signal.
d . EXT CLOCK IN jack
This is an input jack for an external clock. If a VCO-1 square wave or the like is
input into this jack, the SAMPLE & HOLD will synchronize to the signal that is
input.
e . Sample & hold input level slider
Adjusts the level of the signal that is input to the sample & hold circuit.
f . CLOCK RATE slider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [0 .2Hz . . .24Hz]
Adjusts the frequency of the internal clock.
g . ELECTRONIC SWITCH A jack
This is an analog switch that synchronizes to the clock. ELECTRONIC SWITCH
B and C are used together.
h . ELECTRONIC SWITCH B jack
This is an analog switch that synchronizes to the clock. ELECTRONIC SWITCH
A and C are used together.
i . ELECTRONIC SWITCH C jack
This is an analog switch that synchronizes to the clock. ELECTRONIC SWITCH
A and B are used together. Jacks A-C and jacks B-C are alternately connected in
synchronization with the clock.
Tip: For example if jack A is connected to LEFT INPUT, jack B is connected to
RIGHT INPUT, and jack C is connected to an audio signal, an auto-pan effect is
obtained.