KORG ARP 2600 M Analog Synthesizer Module with Carrying Case - Manual (Page 7)

- 7 -
Owner
’s manual
Front panel (VCO-1 section)
a
b
c
k
l
g
h
i
j
d e f
VCO-1 (Voltage Controlled Oscilator 1)
a . INITIAL OSCILLATOR FREQUENCY slider . . . . . . . . . . . . . . . . . . .[10( .03)Hz…10K(30 .)Hz]
Broadly adjusts the VCO-1 pitch.
The frequency range is an approximate value.
b . FINE TUNE slider
Finely adjusts the VCO-1 pitch.
c . CV input 1 jack
This is the pitch CV input jack for VCO-1. The KBD CV is internally connected.
d . CV input 2 jack
This is the pitch CV input jack for VCO-1. The S/H OUT is internally connected.
e . CV input 3 jack
This is the pitch CV input jack for VCO-1. The ADSR is internally connected.
f . CV input 4 jack
This is the pitch CV input jack for VCO-1. The sine wave of VCO-2 is internally
connected.
g . AUDIO/LF select switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [KBD ON, KBD OFF]
Selects whether to use VCO-1 as an audio signal or as an LFO. When using
VCO-1 as an LFO (KBD OFF), the KBD CV will no longer be input into VCO-1.
h . CV input 2 slider
Adjusts the signal level of VCO-1 CV input 2.
i . CV input 3 slider
Adjusts the signal level of VCO-1 CV input 3.
j . CV input 4 slider
Adjusts the signal level of VCO-1 CV input 4.
k . SAWTOOTH output jack
Outputs the sawtooth wave of VCO-1.
l . SQUARE output jack
Outputs the square wave of VCO-1.