Nikon D750 DSLR Camera (Body Only) - Manual (Page 260)

232
❚❚
Ending Time-Lapse Photography
To end time-lapse photography before all the photos are taken,
highlight
Off in the time-lapse photography menu and press J ,
or press J between frames or immediately after a frame is
recorded. A movie will be created from the frames shot to the
point where time-lapse photography ended. Note that time-
lapse photography will end and no movie will be recorded if the
power source is removed or disconnected or the destination
memory card is ejected.
❚❚
No Photograph
The camera will skip the current frame if it is unable to focus
using single-servo autofocus (
AF-S or single-servo autofocus
selected for AF-A ; note that the camera focuses again before each
shot). Shooting will resume with the next frame.
D Time-Lapse Photography
Time-lapse is not available in live view ( 0 54, 66), at a shutter speed of
A or % ( 0 95), when bracketing ( 0 202), High Dynamic Range
(HDR, 0 177), multiple exposure ( 0 216), or interval timer
photography ( 0 222) is active. Note that because shutter speed and
the time needed to record the image to the memory card may vary
from shot to shot, the interval between a shot being recorded and the
start of the next shot may vary. Shooting will not begin if a time-lapse
movie can not be recorded at current settings (for example, if the
memory card is full, the interval or shooting time is zero, or the interval
is longer than the shooting time).
Time-lapse photography may end if camera controls are used or
settings are changed or HDMI cable is connected. A movie will be
created from the frames shot to the point where time-lapse
photography ended.