No photograph – Nikon D750 DSLR Camera (Body Only) User Manual
Page 255
227
❚❚
No Photograph
The camera will skip the current interval if any of the following
situations persist for eight seconds or more after the interval was
due to start: the photograph or photographs for the previous
interval have yet to be taken, the memory card is full, or the
camera is unable to focus in
AF-S
or when single-servo AF is
selected in
AF-A
(note that the camera focuses again before each
shot). Shooting will resume with the next interval.
D
Out of Memory
If the memory card is full, the interval timer will remain active but no
pictures will be taken. Resume shooting (
226) after deleting some
pictures or turning the camera off and inserting another memory card.
A
Interval Timer Photography
Choose an interval longer than the time needed to take the selected
number of shots. If the interval is too short, the number of photos
taken may be less than the total listed in Step 2 (the number of
intervals multiplied by the number of shots per interval). Interval timer
photography can not be combined with long time-exposures (bulb or
time photography,
95) or live view or time-lapse photography
54, 229) and is not available in movie live view (
Record movies
is selected for Custom Setting g4 (
Assign shutter
button
373). Note that because the shutter speed, frame rate, and
time needed to record images may vary from one interval to the next,
the time between the end of one interval and the beginning of the
next may vary. If shooting can not proceed at current settings (for
example, if a shutter speed of
A
or
%
is currently selected in
manual exposure mode, the interval is zero, or the start time is in less
than a minute), a warning will be displayed in the monitor.
Interval timer shooting will pause when
E
(self-timer) or
V
mode is
selected or if the camera is turned off and then on again (when the
camera is off, batteries and memory cards can be replaced without
ending interval timer photography). Pausing shooting does not affect
interval timer settings.