Setting up projector network e-mail alerts – Epson EpiqVision Flex CO-W01 3000-Lumen WXGA 3LCD Projector User Manual
Page 41
41
Setting Up Projector Network E-Mail Alerts
You can set up the projector to send you an e-mail alert over the network if there is a problem with the
projector.
Note:
If the
Standby Mode
setting is set to
Communication On
, you can receive e-mail alerts even if
the projector is in standby mode (the power is off). You must be connected to a network with the
Wireless LAN
>
Connection Mode
setting set to
Advanced
.
1.
Press the
Menu
button.
2.
Select the
Network
menu and press
Enter
.
3.
Select
Network Configuration
and press
Enter
.
4.
Select the
Notifications
menu and press
Enter
.
5.
Turn on
Mail Notification
.
6.
Enter the IP address for the
SMTP Server
setting.
Note:
Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x is a
number from 0 to 255).
7.
Select a number for the SMTP server
Port Number
setting, from 1 to 65535 (default is 25).
8.
Enter the sender's email address as the
From
setting.
9.
Choose an
Address Setting
field, enter the e-mail address, and select or deselect the alerts you
want to receive there. Your e-mail address can be up to 32 alphanumeric characters long. Repeat
for up to three addresses.
Note:
You can enter up to 63 characters for the email address if you use Web Config.
10. When you finish selecting settings, select
Complete
and follow the on-screen instructions to save
your settings and exit the menus.
Note:
If a critical problem causes a projector to shut down, you may not receive an e-mail alert.
Network Projector E-mail Alert Messages
Parent topic: