Epson EpiqVision Flex CO-W01 3000-Lumen WXGA 3LCD Projector - Manual (Page 100)

100
Note: When the A/V Mute Timer setting is enabled, the lamp uses less power when A/V Mute is
activated.
Parent topic: Adjusting the Menu Settings
Projector Information Display - Info Menu
You can display information about the projector and input sources by viewing the Info menu. However,
you cannot change any settings in the menu.
Select Projector Info to display the settings described below. Select Version to display the projector's
firmware version.
Information item Description
Lamp Hours Displays the number of hours the projector has been used in High
and Low (Eco) modes since it was turned on
Source Displays the name of the port to which the current input source is
connected
Input Signal Displays the input signal setting of the current input source
Resolution Displays the resolution of the current input source
Refresh Rate Displays the refresh rate of the current input source
Sync Info Displays information that may be needed by a service technician
Status Displays information about projector problems that may be needed
by a service technician
Serial Number Displays the projector's serial number
Event ID Displays the Event ID number corresponding to a network problem;
see the list of Event ID codes.
Event ID Code List
Parent topic: Adjusting the Menu Settings
Event ID Code List
If the Event ID option on the Info menu displays a code number, check this list of Event ID codes for the
solution to the projector problem associated with the code.