beautypg.com

Solutions when the image is flickering – Epson EpiqVision Flex CO-W01 3000-Lumen WXGA 3LCD Projector User Manual

Page 117

background image

117

Related references

Supported Video Display Formats

Related tasks

Adjusting Picture Quality in Detail

Solutions When the Image is Flickering

If the projected screen flickers, try the following solutions:

• If the screen flickers only when a video signal is input, try replacing the cable connecting the projector

and video device.

• If

Light Output

is set to

Low (Eco)

, change this to

High

and try projecting an image for about two

hours to see if it still flickers.

• Disconnect all the cables connecting the projector and video devices, confirm no signal is being input,

and then reset all the projector settings by enabling the

Reset All Config

setting in the projector's

Reset

menu.

Parent topic:

Solving Image or Sound Problems

Related references

Image Quality Settings - Image Menu
Projector Reset Options - Reset Menu

Solutions When the Image Brightness or Colors are Incorrect

If the projected image is too dark or light, or the colors are incorrect, try the following solutions:

• Try selecting a color mode that best fits the image and environment.

• Check your video source settings.

• Adjust the available settings on the Image menu for the current input source, such as

Brightness

,

Contrast

,

Tint

, and/or

Color Saturation

.

• Make sure all the cables are securely connected to the projector and your video device. If you

connected long cables, try connecting shorter cables.

• Position the projector close enough to the screen.

Parent topic:

Solving Image or Sound Problems

Related references

Image Quality Settings - Image Menu
Available Color Modes