Solutions to password problems – Epson EpiqVision Flex CO-W01 3000-Lumen WXGA 3LCD Projector User Manual

Page 119

119

• Press the

mute button on the remote control to resume audio if it was temporarily muted.

• Press the

A/V mute button on the projector remote control to resume video and audio if they were

temporarily stopped.

• Make sure the

Audio Out Device

settings are correct.

• Check your computer or video source to make sure the volume is turned up and the audio output is set

for the correct source.

• If you do not hear sound from an HDMI source, set the connected device to PCM output.

• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac

supports audio through the HDMI port. If not, you need to connect an audio cable.

Parent topic:

Solving Image or Sound Problems

Related references

Projector Feature Settings - Settings Menu

Solutions to Password Problems

If you cannot enter or remember a password, try the following solutions:

• You may have turned on password protection without first setting a password. Try entering

0000

using

the remote control. If you lose the remote control, you cannot enter a password. Order a new one from
Epson.

• If you have entered an incorrect password too many times and see a message displaying a request

code, write down the code and contact Epson. Do not attempt to enter the password again. Provide
the request code and proof of ownership for assistance in unlocking the projector.

• If you set a Epson Web Control password and forgot the user ID or password, try entering the

following:

• User ID:

EPSONWEB

• Default password: projector serial number

• If you set a Remote password (in Epson Web Control) and forgot the user ID or password, try entering

the following:

• User ID:

EPSONREMOTE