Epson WorkForce WF-2960 Wireless All-in-One Color Inkjet Printer User Manual

Page 250

250

LCD screen message

Condition/solution

Check that the printer
driver is installed on the
computer and that the
port settings for the
printer are correct.

Make sure the printer port is selected correctly on the Port tab of the Printer
Properties screen (Windows) or the

System Properties

USB

list (Mac).

Select

USBXXX

for a USB connection or

EpsonNet Print Port

for a network

connection.

Check that the printer
driver is installed on the
computer and that the
USB port settings for the
printer are correct.

Recovery mode

Update Firmware

An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.

Note:

The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.

During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.

Parent topic:

Solving Problems

Related references

Paper Source Settings Options
Where to Get Help

Related topics

Solving Paper Problems