Sony Ultra Wide Converter For SEL16F28 and SEL20F28 - Manual (Page 58)

4. Network Functions 58
Using Web Remote Control
You can access the web remote control built
into the camcorder from a tablet or computer
over a network connection.
Using the web remote control allows you to
operate the camcorder remotely. You can
start/stop recording and adjust the recording
settings with a connected device. This function
is useful for setting the camcorder in a remote
place, such as the top of a crane, etc.
Camera Control screen
Main screen
ˎ ˎ Status display
ˎ ˎ Record start/stop button
ˎ ˎ ND filter slider
ˎ ˎ Iris slider
ˎ ˎ Focus slider
ˎ ˎ Zoom slider
ˎ ˎ Shooting settings (Custom shooting mode
(page 24))
S&Q Frame Rate, Shutter, Color Temp/Tint,
Gain, Gamma, Shutter Category, White
Mode, Base Sensitivity, Auto ND Filter, Auto
Iris, AGC, Color Bars, Focus Mode, Auto
White
ˎ ˎ Shooting settings (Cine EI shooting mode)
S&Q Frame Rate, Shutter, Color Temp/Tint,
Exposure Index, Color Gamut/Gamma,
Shutter Category, White Mode, Base ISO,
Auto ND Filter, Auto Iris, AGC, Color Bars,
Focus Mode, Monitor LUT, Auto White
Playback screen
ˎ ˎ Status display
ˎ ˎ Playback control buttons
F Rev, Play/Pause, F Fwd, Prev, Stop, Next
Cursor screen
ˎ ˎ Status display
ˎ ˎ Cursor control buttons, menu/status display
Up, Left, Set, Right, Down, Cancel/Back,
Menu, User Menu, Thumbnail, Status
Assign screen
ˎ ˎ Status display
ˎ ˎ Assignable button display
Assignable buttons 1 to 10, Focus Hold
button
Displaying the Web Remote
Control
1
Connect the camcorder and device via a
network connection (page 49).
2
Launch a browser on the device, then
access “http://IP address of camcorder/
rm.html.”
For example, if the IP address is
192.168.122.1, enter “http://192.168.122.1/
rm.html” in the address bar.
You can check the IP address of the
camcorder on the Network Status screen
(page 14).
3
Enter the user name and password
(Access Authentication >User Name and
Password in the Network menu).
When connection is successful, the web
remote control screen appears on the
device.
You use the Wi-Fi Remote screen to
operate the camcorder.
The buttons become unavailable when
the Lock switch is dragged to the right.
[Notes]
ˎ ˎ The web remote control screen may not match
the camcorder settings under the following
circumstances. If this occurs, reload the browser
window.
– If the camcorder is restarted while connected
– If the camcorder is operated directly while
connected
– If the device has been reconnected
– If the browser Forward/Back buttons have been
used
ˎ ˎ The web remote control may not function if the
wireless signal strength becomes weak.