Sony Ultra Wide Converter For SEL16F28 and SEL20F28 - Manual (Page 23)

2. Preparation: Attaching Devices 23
Attaching the XDCA-FX9
You can add functions to the camcorder, such
as a V-shoe battery or wired LAN, by attaching
an XDCA-FX9 Extension Unit (option) to the
camcorder.
[Notes]
ˎ ˎ The camcorder battery pack cannot be attached
when an XDCA-FX9 unit is attached to the camcorder.
You must attach a battery pack to the XDCA-FX9 or
connect an external power supply.
ˎ ˎ Attach/remove the XDCA-FX9 while the camcorder is
turned off.
1
Remove the battery pack (page 16)
attached to the camcorder.
2
Remove the two screws, and remove the
cover of the extension unit connector
block from the camcorder.
3
Align the protrusions of the XDCA-FX9
with the left and right grooves of the
camcorder and slide it all the way in and
then down into the connector block.
Grooves Protrusions
4
Tighten the two screws on the top of the
XDCA-FX9 to secure the XDCA-FX9.
Removing the XDCA-FX9
Loosen the two screws on the top of the
XDCA-FX9, and remove the XDCA-FX9 from the
camcorder.
Attaching a V-Shoe Battery
Insert the V-shoe battery into the battery pack
attachment on the XDCA-FX9.
Removing a V-shoe battery
Pull the V-shoe battery out from the battery
pack attachment on the XDCA-FX9 while
holding down the battery release lever.
Attaching the Dongle Guards
You can attach a dongle guard to protect a
modem or other USB device attached to a USB
connector.
Attach the dongle guard and dongle guard
mounting bracket to the extension unit, and
secure in position using mounting bracket
screws.
Dongle guard mounting
plate
Attaching using fastener strap
Attach the fastener strap to the dongle guard
to secure a USB device in place.
Attach the loop of the strap to the back of
the dongle guard and pass the strap over the
guard as shown below.
Fastener strap
Loop