Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 56)

56
Messages Displayed on the LCD Panel
In addition to the setup items and status display, warning messages indicating that an operation was not executed and
error messages indicating that an operation was not successful are also displayed.
The following table describes the meaning and remedy for typical messages.
Warning messages
Error messages
Message Meaning Cause and remedy
*** CAMERAS WILL REMAIN
UNREGISTERED The number of cameras registered
successfully is smaller than the number of
detected cameras.
“***” indicates the number of cameras that
could not be registered.
This message may be displayed when making camera
assignments using AUTO IP SETUP >SETUP IP or
AUTO IP SETUP >ASSIGN CAM.
• The camera IP addresses are outside the range set
by the start address in [FROM] and the end address
in [TO]. Reconfigure the start address in [FROM]
and the end address in [TO].
• The number of cameras that can be registered in
the camera table exceeds the maximum number.
Re-select the cameras to register.
NO CAMERA WAS FOUND No cameras were detected. This message may be displayed when making camera
assignments using AUTO IP SETUP >SETUP IP or
AUTO IP SETUP >ASSIGN CAM.
• Reconfigure the start address in [FROM] and the
end address in [TO].
• Check the connection status of the unit and
cameras, and the camera power supply status.
• Connect the unit and cameras using the VISCA
over IP (LAN) connection method.
ALL CAMERAS HAVE BEEN
REGISTERED All of the detected cameras have been
registered. This message may be displayed when making camera
assignments using AUTO IP SETUP >SETUP IP or
AUTO IP SETUP >ASSIGN CAM.
All of the detected cameras are registered. Re-select
the cameras to register.
CAMERA TABLE WAS NOT
CHANGED The camera table has not been changed.
Message Meaning Cause and remedy
DUPLICATE IP ADDRESS
PLEASE CHANGE IP ADDR There are devices with duplicate IP addresses
on the network. This message is displayed when the network
connection settings are checked.
Specify different IP addresses.
INVALID IP ADDRESS
PLEASE CHANGE IP ADDR There is a device configured with an IP
address that cannot be used on the network. This message is displayed when the network
connection settings are checked.
Change the IP address of the device.
INVALID SUBNET MASK
PLEASE CHANGE SM There is a device configured with a subnet
mask that cannot be used on the network. This message is displayed when the network
connection settings are checked.
Change the subnet mask setting of the device.
INVALID GW ADDRESS
PLEASE CHANGE GW ADDR There is a device configured with a default
gateway that cannot be used on the network. This message is displayed when the network
connection settings are checked.
Change the default gateway setting of the device.