Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 51)

51
CONFIG
This menu is used to configure functions of the unit.
RM SETUP
Sets the operation of the unit.
AE CONFIG
You can select the following exposure modes when the
AE button on the lens control block is off. To apply the
setting, after selection, turn the AE button on and then
off again.
CAM POWER
Note
SRG-300SE, SRG-301SE, and SRG-201SE do not
switch to standby mode.
ZOOM
CAMERA FREQ
* The shutter speed is displayed in the status display (page 43).
LCD BRIGHT
Adjusts the brightness of the LCD panel in five
increments, 1 (dark) to 5 (bright).
LAMP DIMMER
Adjusts the brightness of the LED buttons in five
increments, 1 (dark) to 5 (bright).
SW ASSIGN
Assign functions to the ASSIGN 1 to ASSIGN 6 buttons
of the unit.
For details about function assignments to assign buttons,
see “Assigning Functions to Assign Buttons” (page 40).
DIRECTION
Sets the control direction of the joystick, ZOOM lever,
and FOCUS knob.
JOYSTICK PAN
Settings (Bold:
default value) Description
MANUAL The gain (GAIN), electronic shutter
speed (SPEED), and iris (IRIS) can be
adjusted manually.
SHUT Pri Automatically adjusts the exposure
using the gain and iris. Adjust the
electronic shutter speed (SPEED)
manually.
IRIS Pri Automatically adjusts the exposure
using the gain and electronic shutter
speed. Adjust the iris (IRIS) manually.
GAIN Pri Automatically adjusts the exposure
using the electronic shutter speed
(SPEED) and iris (IRIS). Adjust the
gain (GAIN) manually.
Settings (Bold:
default value) Description
EACH Only the target camera turns on/off
when using the CAM POWER button.
ALL All cameras registered in the camera
table turn on/off when using the CAM
POWER button.
Settings (Bold:
default value) Description
LEVER Controls the zoom of the target camera
using the ZOOM lever on the lens
control block.
JOYSTICK Controls the zoom of the target camera
using the ZOOM ring on the joystick.
BOTH Controls the zoom of the target camera
using both the ZOOM lever and the
ZOOM ring on the joystick.
Settings (Bold:
default value) Description
59.94, 50, 23.98 Selects the frame rate for the shutter
speed displayed in the menu. You can
select from 59.94 [Hz], 50 [Hz], and
23.98 [Hz].
*
Settings (Bold:
default value) Description
STANDARD Inclining the joystick to the right pans
the camera to the right. Inclining to the
left pans the camera to the left.
REVERSE Inclining the joystick to the right pans
the camera to the left. Inclining to the
left pans the camera to the right.