Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 26)

26
Using a Setup PC
When the unit is connected with cameras by LAN
connection, you can save the settings saved on the unit
to a setup PC by connecting the PC to the network.
The configuration data saved on the PC can be used to
recover settings if a failure occurs or can be used to
configure another remote controller.
You can also update the firmware of the unit.
Saved configuration data
• CONFIG MENU settings of the unit
• Camera table
• Control panel status
For details about connecting the setup PC to a network,
see “Connecting remote controllers, cameras, and setup
PC using LAN connection” (page 16).
System requirements for the setup PC
The following operating environment is required for the
PC on which to install the setup software.
• CPU: Intel Core2 Duo 2.4 GHz or higher
(recommended)
• Memory: 1 GB or more (recommended)
• Hard disk: More than 50 MB free space
• OS: Microsoft Windows 7, Windows 8.1 Pro,
Windows 10 Pro 32-bit or 64-bit version
• Web browser: Windows Internet Explorer Ver. 11.0
Accessing a remote controller
To access the unit from the setup PC, perform the
following procedure beforehand using the RM menu.
1
Press the RM MENU button, turning it on
(button is lit yellow).
The RM menu top menu appears.
2
Turn the SELECT knob to move the cursor
to MAINTENANCE.
3
Press the SELECT button.
The MAINTENANCE menu appears.
4
Turn the SELECT knob to move the cursor
to UPDATE MODE.
5
Press the SELECT button.
The UPDATE MODE setup screen appears.
6
Turn the VALUE knob to change OFF to ON,
then press the VALUE button.
The buttons and LED indicators start blinking, and
a one-time password for accessing the unit from a
web browser is displayed on the LCD panel.
Notes
• The one-time password will become invalid if the
unit is rebooted or UPDATE MODE is set to OFF.
In this case, acquire another one-time password.
• To return to normal operating mode after setting
UPDATE MODE to ON, set UPDATE MODE to
OFF and then press the VALUE button.
7
Access the URL of the target IP controller
using a web browser on the PC.
To save configuration data on a PC (backup) or
restore:
http://:52382/backup/
To update the firmware:
http://:52382/versionup/
The Windows authentication dialog appears.
8
Enter the user name and password in the
Windows authentication dialog.
• User name: RM_IP_USER
• Password: One-time password obtained by the
UPDATE MODE setting.
9
Click the OK button.
The [Backup/Restore] screen or [Firmware Update]
screen appears.
Saving configuration data on a PC
(Backup)
1
Access the URL of the remote controller
whose configuration data you want to save
using a web browser on the PC.
http://:52382/backup/
2
Access the save target remote controller.
For details about the access method, see “Accessing
a remote controller” (page 26).
The [Backup/Restore] screen appears.