Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 36)

36
Storing the Camera
Status (Preset Function)
The camera status, comprising the camera position,
zooming, focusing, backlighting compensation, flicker
compensation, and white/black balance adjustments,
can be stored in the memory of the camera.
You can set the speed of movement between positions
for memory preset operation using OPERATION
>OTHER >PRST SPEED in the RM menu. This setting
is applied to all presets.
The speed of movement default setting is 24.
The number of presets varies depending on the camera.
For details, refer to the specifications for the camera.
1
Press the ACTIVE buttons, turning them on
(buttons are lit), on the joystick control
block and preset memory control block.
2
Select the camera whose status you want
to store.
For details about selection, see “Selecting a
Camera” (page 29).
Note
If “PRST:TRACE” is displayed at the bottom of the
LCD panel, press an assign button to change the
preset mode to MODE1 or MODE2.
Each time you press an assign button, the preset
mode switches between MODE1/MODE2 and
TRACE. MODE1 is selected when
“PRST:MODE1” is displayed. MODE2 is selected
when “PRST:MODE2” is displayed.
For details about function assignments to assign
buttons, see “Assigning Functions to Assign
Buttons” (page 40).
3
Operate the joystick to pan/tilt the
orientation of the camera.
4
Perform zoom, focus, backlight
compensation, flicker compensation, and
white/black balance adjustments, as
required.
5
Check that the DIRECT RECALL button is
off.
Turn it off if it is currently turned on.
6
Enter the preset number you want to store.
Use the PRESET 10/0 button to enter a “0” digit.
The maximum number that can be saved varies
depending on the camera.
The preset number is displayed at the bottom right
on the LCD panel of the menu control block.
7
Press and hold the STORE button.
The camera status is stored in the memory of the
camera.
The preset number at the bottom right of the LCD
panel is displayed highlighted, and storing is
completed when the display disappears.
After registering a preset, we recommend that you
check that the camera status is stored correctly by
recalling the preset.
Recalling stored status
There are two methods for recalling stored status: direct
recall and number recall.
Pressing and holding the CLEAR button cancels the
operation by the recall, and then the movement stops at
its position.
Direct recall
With the DIRECT RECALL button on (button is lit
yellow), press the PRESET 1 to PRESET 10/0 buttons to
recall preset numbers 1 to 10.
Only preset numbers 1 to 10 can be recalled using direct
recall.
Number recall
With the DIRECT RECALL button off (button is not
lit), enter the preset number using the PRESET 1 to
PRESET 10/0 buttons, in the same way as when storing
a preset, and then press the RECALL button.
In this method, the entered preset number is displayed at
the bottom right on the LCD panel of the menu control
block.
Preset numbers 1 to 100 can be recalled using number
recall.
5 1
8
1
9
Direct recall
Number
recall