Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 24)

24
Configuring a serial connection
After cameras are connected correctly, select serial
connection using CONFIG >SERIAL in the RM menu,
set the baud rate, and assign camera addresses.
Note
If a connected camera is changed after completing the
configuration, the cameras must be configured again.
1
Press the RM MENU button, turning it on
(button is lit yellow).
The RM menu top menu appears.
2
Turn the SELECT knob to move the cursor
to CONFIG.
3
Press the SELECT button.
The CONFIG menu appears.
4
Turn the SELECT knob to move the cursor
to SERIAL, and press the SELECT button.
The SERIAL menu appears.
Set the baud rate, as required.
Turn the SELECT knob to move the cursor to
BAUD RATE, turn the VALUE knob, and select
9600 or 38400.
The default setting is 9600.
5
Turn the SELECT knob to move the cursor
to APPLY.
6
Turn the VALUE knob to change NOT EXEC
to EXEC, then press the VALUE button.
The following message appears after changing the
connection method from LAN connection to serial
connection or changing the baud rate, prompting
you to reboot the unit.
7
Turn the VALUE knob to change NO to YES,
then press the VALUE button.
The unit reboots automatically.
Upon rebooting, the serial connection setting is
completed.
2 ~ 8
1