Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 29)

29
Operations
Before operation, make sure that cameras, the unit, and
peripheral devices are installed and connected correctly.
Turning on the Power
1
Turn on the camera(s).
2
Set the power switch on the rear of the unit
to the
^ (on) position.
Note
When the unit is mounted in a control console, turn
the power on/off using the main power supply of
the console.
When the unit is first turned on, all the buttons on
the operation panel light up and then turn off.
Next, the buttons that were selected when the unit
was last turned off light up. The CAMERA 1 button
is lit yellow the first time the unit is turned on.
When using a LAN connection, the camera group
number that was selected when the unit was last
turned off is displayed in the group number display.
3
Turn on the peripheral devices.
Notes
• Be sure to turn on the power of the cameras
before the power of this unit.
• Do not touch the joystick or ZOOM lever when
turning on the power of the unit. Touching the
joystick or ZOOM lever will prevent the center
point position check from operating correctly
when power is applied.
To turn the unit off
To turn the unit off to change connection or perform
maintenance, use the reverse procedure of turning the
unit on.
To turn the cameras on/off (standby)
using the unit
If power is supplied to a camera, you can turn the camera
on/off (standby) using the CAM POWER button of the
color adjustment block.
• Select the camera that you want to turn on/off
(standby), and press the CAM POWER button. When
the camera turns on, the CAM POWER button lights
up. When the camera is off (standby), the button is not
lit.
• You can turn all cameras registered in the camera table
on/off (standby) at the same time by setting CONFIG
>CAM POWER to ALL in the RM menu and pressing
the CAM POWER button.
Selecting a Camera
Assign camera numbers to the cameras, and then select
a camera number on the camera selection block when
you want to control the corresponding camera.
The number of camera numbers that can be assigned to
cameras to control varies depending on the use of LAN
connection or serial connection. The method of
selecting the camera number also is different.
Selecting a camera when using
LAN connection
For LAN connection, ten camera numbers are
assignable in camera groups 1 to 10, supporting
assignment of up to 100 cameras.
1
Select the camera group to which the target
camera belongs using the GROUP LEFT
button and GROUP RIGHT button.
You can select from group 1 to 10.
The number of the selected group is displayed in
the group number display.
After switching the group number, the CAMERA 1
button is selected in the group.
2
Press the number of the CAMERA button to
select.
The selected button lights in yellow.
1
2