Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 53)

53
LAN
Configures the network of the unit when the unit and
target cameras are connected by LAN connection.
For details, see “Setting the IP address of the unit”
(page 14).
SERIAL
Configures serial connections when the unit and target
cameras are connected by serial connection.
For details, see “Configuring a serial connection”
(page 24).
CONTROL I/F
Displays the enabled control interface of cameras.
When LAN connection is enabled, LAN is displayed.
When serial connection is enabled, SERIAL is
displayed.
AUTO IP SETUP
This menu is used to configure the automatic assignment
of IP addresses of the detected cameras on the network.
This is used when the unit and cameras are connected by
LAN connection.
SETUP IP
Assigns IP addresses to cameras automatically, and then
assign the cameras to the camera selection buttons of the
unit.
For details, see “Assignment using AUTO IP SETUP
>SETUP IP” (page 17).
ASSIGN CAM
Assigns cameras that already have configured IP
addresses to the camera selection buttons of the unit.
For details, see “Assignment using AUTO IP SETUP
>ASSIGN CAM” (page 18).
CLEAR TABLE
Clears the camera information.
For details, see “To clear the camera table” (page 19).
SWAP CAM
Swaps the camera number and camera information of
two cameras registered in the camera table.
For details, see “To swap camera numbers” (page 19).
MANUAL
Used to change the group number, camera number, and
IP address assigned to a camera or clear the camera
registration manually.
For details, see “Changing the camera registration and
settings manually” (page 20).
CAMERA TABLE
Displays the camera information (IP address and MAC
address) registered in the camera table.
For details, see “To check the camera table” (page 20).
CAMERA
LINK
setting Control
lamps SETTING setting
IN OUT
OFF Tally input
lamps 1 to 10 Displays the
tally input
lamp
corresponding
to the number
of the camera
with tally input
ON. Not lit
Camera tally
lamp The camera tally lamps are not
controlled. A tally lamp ON/
OFF command is not sent.
ON Tally input
lamps 1 to 10 Displays the
tally input
lamp
corresponding
to the number
of the camera
with tally input
ON. Not lit
Camera tally
lamp Displays the
camera tally
lamp
corresponding
to the number
of the camera
with tally input
ON. The tally lamp
of the target
camera
becomes the
control target,
and the camera
tally lamp
lights up.