Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 10)

10
Rear
A Anti-theft wire attachment point
Attach a wire to prevent theft.
B Ground connection
C
GPI I/O connector
Used as a tally input from an external device or as a
contact output connector of the selected camera
number.
D LAN (network) connector (RJ-45)
Use for LAN connection.
Connect a LAN hub (10BASE-T/100BASE-TX)
using a LAN cable (category 5 or higher).
When a link is established, the green indicator
lights, and it blinks during communication. For
100BASE-TX connections, the yellow indicator
lights.
Notes
• For safety, do not connect the connector for
peripheral device wiring that might have
excessive voltage to this port. Follow the
instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to
prevent malfunction due to radiation noise.
E VISCA RS-422 OUT connector (RJ-45)
Used for VISCA RS-422 serial connection.
F
12V ! (DC power supply input)
connector
Connect to an AC power adapter (sold separately).
G
Cord clamper
Clamp the cord of the AC power adapter to prevent
the cord from being pulled out of the unit.
1 Release the lock of the cord clamper.
2 Connect an AC power adapter.
3 Thread the cord of the AC power adapter
through the cord clamper, then close the lock.
H
Power switch
Turns the power ^ (on) and 1 (off).
Note
When the unit is mounted in a console desk, turn
the power on/off using the main power supply of
the console desk.
I
Screw holes
Mounting points available for use when not
mounting the unit on a flat surface.
Screw holes are provided on all sides, with the
screw holes on the front, left, and right sides
protected by covers (six locations).
3 4 5 7 8 12
9 9
6
Cord clamper
Cord of the AC adapter