Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 38)

38
3
Operate the joystick to pan/tilt the
orientation of the camera.
4
Check that the DIRECT RECALL button is
off.
Turn it off if it is currently turned on.
5
Enter the preset number you want to store.
Use the PRESET 10/0 button to enter a “0” digit.
The maximum number that can be saved varies
depending on the camera.
The preset number is displayed at the bottom right
on the LCD panel of the menu control block.
6
Press and hold the STORE button.
Recording of each operation starts.
REC is displayed highlighted to the right of
PRST:TRACE at the bottom of the LCD panel
during recording.
7
Perform the pan/tilt/zoom operations you
want to record.
8
To stop recording, press the button on the
top of the joystick. Alternatively, re-enter
the preset number entered in step 5, and
press and hold the STORE button.
The REC indicator disappears.
Starting playback of a recorded
trace
Use one of the following methods to start playback of a
recorded trace.
Direct recall
With the DIRECT RECALL button on (button is lit
yellow), you press the PRESET 1 to PRESET 10/0
button in which the operations were recorded to start
playback of the trace. Only preset numbers 1 to 10 can
be recalled using direct recall.
1
Check that the preset mode is set to
TRACE.
2
Press the preset button in which the
operations were recorded.
The camera orientation is set to the position at the
start of the trace.
3
Press and hold the same preset button.
Playback of the recorded trace operations starts.
Number recall
With the DIRECT RECALL button off (button is not
lit), you enter the preset number using the PRESET 1 to
PRESET 10/0 buttons and then press the RECALL
button to start playback of a trace.
1
Check that the preset mode is set to
TRACE.
2
Enter the preset button in which the
operations were recorded.
The entered preset number is displayed at the
bottom right of the LCD panel of the menu control
block.
3
Press the RECALL button.
The camera orientation is set to the position at the
start of the trace.
4
Enter the same preset number, and press
and hold the RECALL button.
Playback of the recorded trace operations starts.
Note
When the operated camera is switched by both via
the GPI I/O connector and NORMAL TALLY
mode setting, the camera's trace operation stops.
(For details on the setting of GPI I/O and TALLY
MODE, see “About the tally input lamp indicators”
(page 30) and “GPI I/O” (page 52).)