Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 19)

19
To add cameras
Perform the configuration again using AUTO IP SETUP
>SETUP IP or AUTO IP SETUP >ASSIGN CAM.
Assigned cameras are added to the bottom of the camera
table.
For details, see “Assignment using AUTO IP SETUP
>SETUP IP” (page 17) or “Assignment using AUTO IP
SETUP >ASSIGN CAM” (page 18).
To clear the camera table
You can clear all the camera information stored in the
camera table.
Note
The camera table cannot be restored once it has been
cleared.
1
Press the RM MENU button, turning it on
(button is lit yellow).
The RM menu top menu appears.
2
Turn the SELECT knob to move the cursor
to AUTO IP SETUP.
3
Press the SELECT button.
The AUTO IP SETUP menu appears.
4
Turn the SELECT knob to select CLEAR
TABLE, and press the SELECT button.
The CLEAR TABLE menu appears.
5
Turn the VALUE knob to change NOT EXEC
to EXEC, then press the VALUE button.
6
Turn the VALUE knob to change NO to YES,
then press the VALUE button.
To swap camera numbers
You can change the camera numbers after IP addresses
have been configured automatically.
1
Press the RM MENU button, turning it on
(button is lit yellow).
The RM menu top menu appears.
2
Turn the SELECT knob to move the cursor
to AUTO IP SETUP.
3
Press the SELECT button.
The AUTO IP SETUP menu appears.
4
Turn the SELECT knob to select SWAP
CAM, and press the SELECT button.
The SWAP CAM menu appears.
This screen is used to swap the camera information
of CAMERA A and CAMERA B.
5
Turn the SELECT knob to move the cursor
to CAMERA A.
6
Turn the VALUE knob to change the camera
group number and the camera number of
the camera to swap.
The IP address and MAC address of the
corresponding camera are displayed in IP and
MAC, respectively.
7
Turn the SELECT knob to move the cursor
to CAMERA B.
8
Enter the camera group number and the
camera number of the camera to swap
using the same procedure for CAMERA A.
9
Turn the SELECT knob to move the cursor
to SWAP A<=>B.
p SWAP A<=>B : NOT EXEC
10
Turn the VALUE knob to change NOT EXEC
to EXEC, then press the VALUE button.
11
Turn the VALUE knob to change NO to YES,
then press the VALUE button.
12
Check the result using AUTO IP SETUP
>CAMERA TABLE in the RM menu.
p CAMERA A : 01-01
Camera number
Group number