Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 16)

16
Connecting remote controllers, cameras, and setup PC using LAN connection
Connection example
1
Connect the LAN connector of the units
and LAN connector of the cameras using
LAN cables.
You can connect up to 100 cameras and five remote
controllers on the same network.
2
To configure setting of the unit and
cameras using setup software, connect a
PC to the same network.
• Use shielded-type LAN cables to prevent
malfunction that may result from radiation noise.
• Use a LAN cable (category 5 or higher).
• Connect the cameras, remote controllers, and PC
via switching hubs (10BASE-T or 100BASE-
TX). Use on a network with significant packet
loss or delay may cause a malfunction. Use a
high-quality network.
• Do not mix 10BASE-T and 100BASE-TX in the
network.
EXT SYNC IN TERMI-
NATION
ON OFF
ON
ON
OFF
LINE OUT SDI 1
OSD
LAN
SDI 2
2 3 4 5 6 7 8 1
MONITOR OUT HDMI OUT SDI 1 SDI 2
IN SYSTEM
SELECT
IR SELECT CAMERA SETUP
1 2 3
VISCA RS - 422 OUT 12V
HDMI OUT SDI OUT SYSTEM
SELECT
MIC
R L
(PLUG IN POWER)
VISCA RS-422 IR SELECT
LAN
MODE VISCA
1 9 1 9
RS-422 TALLY/CONTACT RS-232C !
DC 12V
LAN
RGB/COMPONENT VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON HD SD
IN VISCA RS-232 OUT SDI OUT DC IN 12V
R
VIDEO S VIDEO
SDI OUT LAN
1 2 BRBK-IP10 ON
HD SD
OFF DATA MIX
BAUD RATE
RM-IP500
BRC-H900
BRBK-IP10
IP control card
*3
RM-IP10 Switching hub
BRC-X1000,
BRC-H800
Video switcher *1
SRG-360SHE
Setup PC
Video monitor
Remote control signal: LAN cable (category 5 or higher)
Tally/contact signal: Connection cable *2
Video signal: HDMI cable
Video signal: Connection cable with BNC connectors
Signal flow
*1 For an example connection with a video switcher, see “Connection with a video switcher” (page 25).
*2 Use a connection cable designed for the switcher being used. For the specifications of the GPI I/O connector of
the unit, see “Pin assignments” (page 59).
*3 To connect the BRC-H900 using a LAN connection, a BRBK-IP10 IP control card must be installed. In addition,
use an IP control card with firmware version 2.1 or later.