Roland V-600UHD 4K HDR Multi-Format Video Switcher - Manual (Page 47)

47
LAN/RS-232 Command Reference
LAN Interface
This uses the LAN port on the V-600UHD.
You use Telnet to operate the V-600UHD remotely over a LAN
(TCP/IP protocol).
Communication standards
Port LAN port
Protocol TCP
Port number 8023
Setting the IP address of the V-600UHD
The method of setting the IP address depends on the Configure
setting.
If the Configure setting is “Manually,” use the following procedure to
make the setting.
1. Select the [MENU] button & “System” &
“LAN Control,” and press the [VALUE] knob.
2. Select “IP Address,” and use the [VALUE] knob to set
the IP address.
& Details on menu items: see p. 46.
3. Press the [MENU] button to quit the menu.
RS-232 Interface
RS-232 connector pin layout Pin assignments
1 2 3 4 5
6 7 8 9
DB-9 type (male)
Pin No. Signal
1 N.C.
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 N.C.
Communication standards
Communication method Synchronous (asynchronous), full-duplex
Communication speed 9,600 bps/38,400 bps
Parity none
Data length 8 bits
Stop bit 1 bit
Code set ASCII
Flow control XON/XOFF
Cable wiring diagram
Use an RS-232 crossover cable to connect the V-600UHD and the
controller (an RS-232-compatible computer or other device).
V-600UHD Controller
N.C.: 1 1:
RXD: 2 2: RXD
TXD: 3 3: TXD
DTR: 4 4:
GND: 5 5: GND
DSR: 6 6:
RTS: 7 7:
CTS: 8 8:
N.C.: 9 9:
(Crossover connection)
* The connections between 4 and 6 and between 7 and 8 are inside
the V-600UHD.
Command Format
Commands are formatted using the configuration shown below.
Commands are all in ASCII code.
stx Command code : Parameter , Parameter ;
stx
ASCII code “02H” is a control code indicating the start of a
command. “H” indicates that it is a hexadecimal value.
Command code This specifies the command type (3 letters of the alphabet).
Parameter
This is appended to a command that requires one or more
parameter. The command and the parameter portion are
separated by a “ : ” (colon). When there are multiple parameters,
they are each separated by “ , ” (comma) characters.
;
This is the code that the V-600UHD recognizes as the end of a
command.
* The codes of stx (02H), ACK (06H), and XON (11H)/ XOFF (13H) are
the control codes.
V-600UHD support two types of remote-interface communication: LAN and RS-232.
Using the LAN port or RS-232 connector to send specific commands to the V-600UHD from a controlling device lets you operate the V-600UHD
remotely.