Roland VR-6HD Direct Streaming AV Mixer - Manual (Page 81)

81
Other Functions
Loading
Here’s how to load the sequencer settings that are saved on a storage.
When you load settings, the current sequencer settings are overwritten.
1 . [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“SEQUENCER”, and press the [VALUE] knob.
The setup screen appears.
2 . Use the [VALUE] knob to select “LOAD FROM STORAGE”, and
press the [VALUE] knob.
The sequence files in the storage are listed.
* Use the “SD CARD” or “USB MEMORY” selector at the top of the screen
to switch between the storage media to load from.
3 . Touch the sequence file that you want to load.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
4 . Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The sequencer settings are loaded. When the operation is finished, the
message “COMPLETED” appears.
5 . Press the [MENU] button to close the menu.
Initializing the Sequencer
Here’s how to initialize the sequencer and erase all the settings.
1 . [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“SEQUENCER”, and press the [VALUE] knob.
The setup screen appears.
2 . Use the [VALUE] knob to select “INITIALIZE”, and then press
the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
3 . Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
4 . Press the [MENU] button to close the menu.
MEMO
About the sequencer demo data
Once you perform a factory reset (p. 94), any demo data you have
edited or deleted is restored to its factory settings.