Roland VR-6HD Direct Streaming AV Mixer - Manual (Page 28)

28
Video Operations
Saving a Still Image to a SD Card or USB Flash Drive
Here’s how a still image captured from the input/output video (p. 26) can be saved to a storage (SD card or USB flash drive).
* You can’t export still images that were created while HDCP (p. 18) was set to “ON”.
NOTE
¹ When using a SD card or USB flash drive for the first time, you
must format it using the VR-6HD (p. 13).
¹ Never turn off the power or remove the SD card or USB flash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB flash drive, it may take some
time to be recognized.
¹ Still images are saved to the “Roland/VR-6HD/still” folder.
1 . Insert the SD card into the SDXC card slot.
* When using a USB flash drive, connect the USB flash drive to the USB
HOST port.
2 . [MENU] button
Ó
“STILL IMAGE”
Ó
select “SAVE TO
STORAGE”, and press the [VALUE] knob.
3 . Touch the screen to select the still image to export.
A list of the still images on the storage media (in the still image folder)
is shown.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
4 . Select “ FILE NAME ” and press the [VALUE] knob.
This brings up the software keyboard for input.
5 . Input the backup file name.
* You can input up to 32 characters.
6 . Touch in software keyboard.
7 .
Select the file type
Use the [VALUE] knob to select “SAVE FORMAT”, and then
press the [VALUE] knob.
Use the [VALUE] knob to select “BITMAP”, “JPEG”, or “PNG”,
and press the [VALUE] knob.
8 . Use the [VALUE] knob to select “SAVE”, and then press the
[VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
9 . Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The still image is written to the storage.
The still image is saved to the “Roland/VR-6HD/still” (still image) folder
on the storage media.
10. Press the [MENU] button to close the menu.
MEMO
Overwriting a still image
When you touch a filename for an existing still image on the screen
in step 5, the filename in the filename list is used. You can overwrite
the name.