Enable character, Default – Datalogic QuickScan Lite QW2100 User Manual
Page 62
RS-232/USB-Com Interfaces
52
QuickScan
TM
Lite QW2100
ENTER/EXIT PROGRAMMING MODE
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
for more detailed programming instructions.
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
has been set as 7 Data Bits.
$CR2EC
Select Enable Character Setting
DEFAULT
0x45 = Enable Character is ‘E’