Datalogic QuickScan Lite QW2100 - Manual (Page 54)

RS-232/USB-Com Interfaces
44 QuickScan TM Lite QW2100
ENTER/EXIT PROGRAMMING MODE
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay. See
Intercharacter Delay on page 250
for more detailed programming instructions.
$CR2IC00 
Intercharacter Delay = No Delay
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 00 = No Intercharacter Delay