Datalogic QuickScan Lite QW2100 - Manual (Page 43)

Scanning Features
Product Reference Guide 33
ENTER/EXIT PROGRAMMING MODE
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
Scan-
ning Active Time on page 247 for more detailed programming instructions.
Stand Mode Flash
Enables/disables the LED flash when the reader is in Stand Mode.
$CSNET
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 005 = Scanning is active for 5 Seconds
$CSMFL00 
Stand Mode Flash = Disable
$CSMFL01 
Stand Mode Flash = Enable
DEFAULT