Chapter 5. rs-232 only interface, Chapter 5, rs-232 only interface, Supplies information about – Datalogic QuickScan Lite QW2100 User Manual
Page 47: Starting on, Rs-232 only interface, Chapter 5, Introduction, Rs-232 standard factory settings, Baud rate
Product Reference Guide
37
Chapter 5
RS-232 ONLY Interface
Introduction
Use the programming bar codes in this chapter if modifications to the standard RS-232 inter-
face settings are necessary to meet your system’s requirements. Additional settings which apply
to both the RS-232 and USB interfaces are available in
Chapter 6, RS-232/USB-Com Inter-
.
RS-232 Standard Factory Settings
for a listing of standard factory settings.
Baud Rate
Baud rate is the number of bits of data transmitted per second. Set the reader's baud rate to
match the baud rate setting of the host device. With an improper baud rate setting, data may
not reach the host correctly.
ENTER/EXIT PROGRAMMING MODE
$CR2BA00
Baud Rate = 1200
$CR2BA01
Baud Rate = 2400
$CR2BA02
Baud Rate = 4800