Ack character nak character, Default, Ack character – Datalogic QuickScan Lite QW2100 User Manual
Page 57: Nak character
ACK NAK Options
Product Reference Guide
47
ENTER/EXIT PROGRAMMING MODE
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
for more detailed programming instructions.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
for more detailed programming instructions.
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
has been set as 7 Data Bits.
$CR2AC
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
has been set as 7 Data Bits.
$CR2NA
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character