Ack nak timeout value, Default – Datalogic QuickScan Lite QW2100 User Manual
Page 58
RS-232/USB-Com Interfaces
48
QuickScan
TM
Lite QW2100
ENTER/EXIT PROGRAMMING MODE
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout. See
for more detailed programming instructions.
$CR2AT
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
01 ACK NAK Timeout value is 200ms