Datalogic QuickScan Lite QW2100 - Manual (Page 275)

Label ID: Set Individually Per Symbology
Product Reference Guide 265
Label ID: Set Individually Per Symbology — continued
Table 18. Label ID Examples
STEP ACTION EXAMPLES
1. Scan the ENTER/EXIT bar code (Reader enters Programming Mode)
2.
Determine placement of the
Label ID characters BEFORE
or AFTER with regard to
scanned data using Label ID
Control on page 71
Enable as Prefix Enable as Suffix Enable as Prefix Enable as Suffix
3.
Scan the bar code selecting the
symbology type you wish to
designate label ID characters
for using Label ID
Symbology
Selection, starting on page
72 .
GS1 DataBar
Omnidirectional
Code 39
Interleaved 2 of
5
Code 32
4.
Custom Label ID example
(desired characters):
D B * = C 3 + P H
5.
Find hex equivalents from the
ASCII table (inside back cover),
then scan in these digits/
characters using the bar codes
in the section:
Keypad, starting on page
297 . f you make a mistake
before the last character, scan
the CANCEL bar code to abort
and not save the entry string.
You can then start again at the
beginning.
44 42 2A 3D 43 33 2B 50 48
6. Scan theENTER/EXIT bar code (Reader exits Label ID entry)
7.
Scan the ENTER/EXIT bar code
once again
(Reader exits Programming Mode)
Result:
DB*[bar code
data]
[bar code
data]=C3
+[bar code data] [bar code data]PH