Indicate transmission failure disable character, Default, Indicate transmission failure – Datalogic QuickScan Lite QW2100 User Manual
Page 61: Disable character
Indicate Transmission Failure
Product Reference Guide
51
ENTER/EXIT PROGRAMMING MODE
Indicate Transmission Failure
This option enables/disables the reader’s ability to sound an error beep to indicate a transmission
failure while in ACK/NAK mode.
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
for more detailed programming instructions.
$CR2TF00
Indicate Transmission Failure = Disable Indication
$CR2TF01
Indicate Transmission Failure = Enable Indication
DEFAULT
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
has been set as 7 Data Bits.
$CR2DC
Select Disable Character Setting
DEFAULT
0x44 = Disable Character is ‘D’