Datalogic QuickScan Lite QW2100 - Manual (Page 31)

Sleep Mode Timeout
Product Reference Guide 21
ENTER/EXIT PROGRAMMING MODE
Sleep Mode Timeout
Specifies the timeout value for the reader to enter Sleep Mode (a very low power consumption
state).
NOTE
RS-232 interface ONLY.
A reader having a Scan Mode setting of Object Sense, Stand
Mode, Flashing, or Always On will not enter Sleep Mode. (The
reader is always internally active when in these modes.)
$CSLTO00 
Sleep Mode Timeout = Disabled
$CSLTO1E 
Sleep Mode Timeout = 30 Seconds
$CSLTO3C 
Sleep Mode Timeout = 1 Minute (60 Seconds)
$CSLTO5A 
Sleep Mode Timeout = 1 Minute 30 Seconds (90 Seconds)
$CSLTO78 
Sleep Mode Timeout = 2 Minutes (120 Seconds)
DEFAULT