PLANET SG-4800 - Manual (Page 60)

Gigabit SSL VPN Security Router User’s Manual
include all Internet IP addresses). Select WAN1 from the pull-down option list “Interface”, and then click
“Enable”. Finally, click “Add New” and the rule will be added to the mode. The device will transmit packets that
are not going to Port 80 to the Internet through WAN1.
Configuring “Assigned Routing Mode” for load Balance
IP Group: This function allows users to assign packets from specific Intranet IP addresses or to specific
destination Service Ports and to specific destination IP addresses through an assigned WAN to the Internet.
After being assigned, the specific WAN will only support those assigned Intranet IP addresses, destination
Service Ports, or destination IP addresses. Those which are not configured will go through other WANs for
external connection. Only when this mode is collocated with “Assigned Routing” can it bring the function into
full play.
Example 1:How do I set up the Assigned Routing Mode to keep all Intranet IP addresses from going
through WAN2 when the destination is Port 80, and keep all other services from going through
WAN1?
As in the figure below, select “HTTP[TCP/80~80]” from the pull-down option list “Service”, and then in the
boxes of “Source IP” input “192.168.1.0 ~ 0” (which means to include all Intranet IP addresses). Retain the
original numbers “0.0.0.0” in the boxes of “Destination IP” (Which means to include all Internet IP addresses).
- 54 -