beautypg.com

PLANET SG-4800 User Manual

Page 59

background image

Gigabit SSL VPN Security Router User’s Manual

Example 2:How do I set up Auto Load Balance Mode to keep Intranet IP 192.168.1.150 ~ 200 from

going through WAN2 when the destination port is Port 80?

As in the figure below, select “HTTP [TCP/80~80]” from the pull-down option list “Service”, and then in the

boxes for “Source IP” input “192.168.1.150” to “200”. Retain the original numbers “0.0.0.0” in the boxes of

“Destination IP” (which means to include all Internet IP addresses). Select WAN2 from the pull-down option

list “Interface”, and then click “Enable”. Finally, click “Add New” and the rule will be added to the mode.

Example 3:How do I set up Auto Load Balance Mode to keep all Intranet IP addresses from going

through WAN2 when the destination port is Port 80 and keep all other services from going through

WAN1?

As in the figure below, there are two rules to be configured. The first rule: select “HTTP [TCP/80~80]” from the

pull-down option list “Service”, and then in the boxes of Source IP input “192.168.1.0” to “0” (which means to

include all Intranet IP addresses). Retain the original numbers “0.0.0.0” in the boxes of “Destination IP”

(Which means to include all Internet IP addresses). Select WAN2 from the pull-down option list “Interface”,

and then click “Enable”. Finally, click “Add New” and the rule will be added to the mode. The device will

transmit packets to Port 80 through WAN2. However, with only the above rule, packets that do not go to Port

80 may be transmitted through WAN2; therefore, a second rule is necessary. The second rule: Select “All

Ports [TCP&UDP/1~65535]” from the pull-down option list “Service”, and then input “192.168.1.2 ~ 254” in the

boxes of “Source IP”. Retain the original numbers “0.0.0.0” in the boxes of “Destination IP” (which means to

- 53 -

This manual is related to the following products: