PLANET SG-4800 - Manual (Page 40)

Gigabit SSL VPN Security Router User’s Manual
WAN default gateway Enter the WAN default gateway, which provided by your ISP.
DNS Servers Enter the DNS server IP address, you must have to enter a DNS server IP
address, maximum two DNS servers IP addresses available..
Intranet routing default
gateway
Enter one of IP addresses that provide by the ISP as your default gateway.
Intranet IP addresses
range
Enter your IP addresses range, which IP addresses are provided by ISP. If you
have multiple IP ranges, you need setup group1 and group 2.
You can also setup the default gateway and IP range in the group 2.
Enable Line-Dropped
Scheduling
The WAN disconnection schedule will be activated by checking this option. In
some areas, there is a time limitation for WAN connection service. For
example: the optical fiber service will be disconnected from 0:00 am to 6:00 am.
Although there is a standby system in the device, at the moment of WAN
disconnection, all the external connections that go through this WAN will be
disconnected too. Only after the disconnected lines are reconnected can they
go through the standby system to connect with the Internet. Therefore, to avoid
a huge number of disconnection, users can activate this function to arrange
new connections to be made through another WAN to the Internet. In this way,
the effect of any disconnection can be minimized.
Line-Dropped Period Input the time rule for disconnection of this WAN service.
Line-Dropped
Scheduling
Input how long the WAN service may be disconnected before the newly added
connections should go through another WAN to connect with the Internet.
Backup Interface
Select another WAN port as link backup when port binding is configured. Users
should select the port that employs the same ISP.
Link Backup Interface
Select another WAN port as link backup when port binding is configured. Users
should select the port that employs the same ISP.
Shared- Circuit WAN
environment:
If your WAN connects to a Switch, select “Enabled” to filter broadcast packets.
The default is “Disabled”.
MTU MTU is abbreviation of Maximum Transmission Unit. “Auto” and “Manual” can
be chosen. The default value is 1500. Different value could be set in different
network environment. (e.g. ADSL PPPoE MTU: 1492)
The default is “Auto”.
Click “Apply” to save the configuration, or click “Cancel" to leave without making any changes.
- 34 -