PLANET SG-4800 - Manual (Page 36)

Gigabit SSL VPN Security Router User’s Manual
Password Input the password issued by ISP.
Connect on Demand This function enables the auto-dialing function to be used for a PPTP dial
connection. When the client port attempts to connect with the Internet, the
device will automatically connect with the default ISP auto dial connection;
when the network has been idle for a period of time, the system will break the
connection automatically. (The default time for automatic break off when no
packets have been transmitted is five minutes).
Keep Alive This function enables the PPTP dial connection to redial automatically when
the connection has been disconnected. Users can set up the redialing time.
The default is 30 seconds.
Enable Line-Dropped
Scheduling
The WAN disconnection schedule will be activated by checking this option. In
some areas, there is a time limitation for WAN connection service. For
example: the optical fiber service will be disconnected from 0:00 am to 6:00 am.
Although there is a standby system in the device, at the moment of WAN
disconnection, all the external connections that go through this WAN will be
disconnected too. Only after the disconnected lines are reconnected can they
go through the standby system to connect with the Internet. Therefore, to avoid
a huge number of disconnection, users can activate this function to arrange
new connections to be made through another WAN to the Internet. In this way,
the effect of any disconnection can be minimized.
Line-Dropped Period Input the time rule for the disconnection of this WAN service.
Line-Dropped
Scheduling
Input how long the WAN service may be disconnected before the newly added
connections should go through another WAN to connect with the Internet.
Link Backup Interface Select another WAN port as link backup when port binding is configured. Users
should select the port that employs the same ISP.
Shared- Circuit WAN
environment
If your WAN connects to a Switch, select “Enabled” to filter broadcast packets.
The default is “Disabled”.
MTU MTU is abbreviation of Maximum Transmission Unit. “Auto” and “Manual” can
be chosen. The default value is 1500. Different value could be set in different
network environment. (e.g. ADSL PPPoE MTU: 1492)
The default is “Auto”.
After the changes are completed, click “Apply” to save the configuration, or click “Cancel" to leave without
making any changes.
- 30 -