TA Triumph-Adler DCC 2520 - Manual (Page 46)

Fax Operation (Basic Use)
2-10
Receiving Documents Automatically (Automatic Fax Reception)
Automatic Fax Reception is the default setting for fax reception in this machine and no special
settings are required for its use. The data for an incoming fax are stored and then printed out in a
single batch at the end of the communication.
NOTE: In order to use the Automatic Fax Reception mode, it is necessary to select the [Fax
Reception] ([Fax Rx]) key under Selecting the Automatic Reception Mode (Receive Mode setting)
on page 7-12.
Reception modes
This fax machine offers the following 4 or 5 (depending upon the region of use) ways to receive a
fax.
• Automatic Fax Reception....Refer to this page.
• Manual Fax Reception.....Refer to page 3-25.
• Auto FAX/TEL Switching.....Refer to page 5-2.
• TAD Reception.....Refer to page 5-4.
• D.R.D. Reception.....Refer to page 5-6.
> Checking the reception mode
Make sure that Auto RX is displayed.
> Changing the reception mode
1 Press the reception mode select key when you want to change the reception mode.
2 Press the key that corresponds to
the desired reception mode.
1 Receiving a fax
When a fax comes in, fax reception will begin automatically after the amount of time equal to a
designated number of rings.
NOTE: Once fax reception begins, the [Status] ([Act status]) key will appear in the bottom right of
the touch panel.
riginal & assign destination.
. 0% for fax transmission.
Application
Abbrev.
TX
Register
Re-dial
On-hook
setting
Dest.
check
Memory TX
Auto RX
Print Report
Memory usage:
OCT-11-2005 16:00
Receive Mode
Manual RX
Answering
Machine
Ready for fax transmission.
Auto RX
Memory
OCT-11