SMA SB 2000HF-30 Installation - Manual (Page 31)

SMA Solar Technology AG The Communication Module (Quick Module)
Installation Manual SB20HF-30HF-IA-en-32 31
5.5 Changes via Rotary Switches after Installation of the
Quick Module
If you have already connected the Quick Module to the inverter and would like for example to
configure the installation country or the display language via the rotary switches, then proceed as
follows:
1. Disconnect the inverter from the AC and DC side as described in section 8 "Disconnecting the
Inverter from Voltage Sources" (page 58).
2. Make sure that the inverter has been secured with the connection element in order to prevent it
from being lifted out, as per section 4.3 "Mounting the Inverter with the Wall Mounting Bracket"
(page 17).
3. Pull the Quick Module out to the first stopper.
4. Flip the flap up and pen the lid until it locks into
place.
5. See section 5.3.4 "Setting the Country Standard and Language using the Rotary Switch"
(page 28) for setting the installation country and the display language.
6. See section 5.3.5 "Communication via Bluetooth" (page 28) for assigning the NetID via
Bluetooth.
7. Close the lid of the Quick Module and flip the flap
down again until it locks into place.