7 commissioning, 1 procedure, 2 configuring the country data set – SMA SB 3600SE-10 User Manual
Page 39: Commissioning, Procedure, Configuring the country data set

7 Commissioning
7.1 Procedure
Before you can commission the inverter, you must check various settings and make changes if
necessary. This section describes the procedure for commissioning and gives an overview of the
steps you must always perform in the prescribed order.
Procedure
See
1.
Check which country data set the inverter is set to.
Supplementary sheet
with the default set-
tings, type label or dis-
play
2.
If the country data set is not set correctly for your country or
your purpose, adjust to the required country data set and corre-
sponding display language.
3.
Commission the inverter and start a self-test, if required.
Section 7.3, page 40
and Section 7.4, page
41
7.2 Configuring the Country Data Set
A display language is assigned to every country data set. Set the country data set appropriate for
your country or purpose, with the corresponding display language, within the first ten feed-in hours
via the rotary switches in the inverter. After the first ten feed-in hours, the country data set can only
be changed by means of a communication product.
If the display language of the country data set does not match the required language, you can
change it after commissioning (see Section 8.2, page 44).
The country data set must be set correctly.
If you select a country data set which is not valid for your country and purpose, it can cause a
disturbance in the PV system and lead to problems with the grid operator. When selecting the
country data set, you must always observe the locally applicable standards and directives as
well as the properties of the PV system (e.g. PV system size, grid-connection point).
• If you are not sure which country data set is valid for your country or purpose, contact
your grid operator for information on which country data set is to be configured.
7 Commissioning
SMA Solar Technology AG
Operating Manual
39
SB36-50SE-BE-en-11