SMA SB 3600SE-10 - Manual (Page 26)

Procedure:
1. Ensure that no cables are laid in the wall which could be damaged when drilling holes.
2.
Risk of injury when drilling through the wall mounting bracket
If you drill through the wall mounting bracket, it could rotate and inflict cuts.
• Do not drill through the wall mounting bracket.
3. Align the wall mounting bracket horizontally on
the wall and mark the position of the five drill
holes.
4. Set the wall mounting bracket aside and drill the marked holes.
5. Insert screw anchors into the drill holes if necessary.
6. Fasten the wall mounting bracket horizontally to the wall using five screws and washers.
7. Hook the inverter into the right-hand side of the
wall mounting bracket. The tabs of the wall
mounting bracket into which the inverter is
hooked should be located approximately in the
center of the inverter.
8. Ensure that the inverter is securely in place.
9. Hook the Battery Pack into the left-hand side of
the wall mounting bracket. The handle on the
right-hand side of the Battery Pack must end up
flush with the hook-in position marked on the
wall mounting bracket.
5 Mounting SMA Solar Technology AG
Operating Manual SB36-50SE-BE-en-11 26